Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 121)

GPS Reference Manual
26
Base Point : displays the base point name chosen in the previous
screen.
Latitude : is where you enter the WGS84
latitude for the base point.
Longitude : is where you enter the WGS84
longitude for the base point.
Ellipse Height : is where you enter the WGS84
ellipsoid height for the base point.
Note: You can enter latitude in dd.mmsssss
format with north positive, or you can enter dd
mm ss.ssssss N/S. You can enter longitude in
ddd.mmsssssss format with east positive or you
can enter ddd mm ss.sssss E/W.
Average position for epochs before GET : instructs the receiver to
average autonomous positions for this number of epochs before
returning.
*36 6WDWXV : opens the GPS Status screen (Page R-20).
*HW 3RVLWLRQ )URP 5[ : queries the receiver for an autonomous
position. This position can then be used to configure the base by
tapping
6(7.
Note: It is highly recommended that you do only one autonomous
base setup per job. This will make it much easier to manage the
transformation from geodetic to local plane coordinates in your job. It
is possible, however, to do multiple autonomous setups in a job. If
you do this, each setup is assigned a unique setup group to identify
them. See the user's manual for more information on setup groups.
6(7 : sets the base position in Survey Pro and configures the receiver
to begin broadcasting differential corrections. When successfully
completed, the Current GPS Base information screen returns with
the new base station information.