Control points, Rover receiver antenna – Spectra Precision Survey Pro CE v3.60 GPS User Manual User Manual
Page 124
Survey Menu – RTK
29
Measured
: is where you enter the height of the antenna, measured to
the location specified on the Rover Receiver Antenna screen.
6HWXS +5 : opens the Rover Receiver Antenna screen, which is
identical to the Base Receiver Antenna screen discussed on Page R-27
where the details of the rover antenna are defined.
Note: the antenna information and receiver serial number is stored
in the registry. When you setup the base or rover receiver and the
receiver serial number matches a number stored in the registry, the
associated antenna parameters are automatically recalled.
Rover Receiver Antenna
6XUYH\ 5RYHU 6HWXS 6HWXS +5
The Rover Receiver Antenna screen is used to define the parameters
of the antenna used with the rover receiver. The screen is identical to
the Base Receiver Antenna screen, which is described on Page R-27.
Control Points
6XUYH\ &RQWURO 3RLQWV
The Control Points screen is used to measure or check control points
in the projection solution.
GPS Status
: displays the current solution type,
radio signal quality, number of satellites used, and
the receiver’s estimate of the horizontal precision of
the current point. If this area is tapped, the GPS
Status screen will open (Page R-20).
Point
: is where you enter the name of the control
point you are occupying.
Rover
: is where you enter the measured height of
the rover antenna.