Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 34)

GPS User’s Manual
30
16. Set any other parameters specific to your brand and model. On
the General card, different receiver brands have special settings
available.
17. Hardware configuration is complete. Tap
2. twice to return to
the Base Setup screen.
RTK Configurations
Note: The following step is only necessary if you need to use
different COM port settings for your base and rover RTK receivers.
18. Set the base or rover configuration. If this receiver is the RTK
base, tap
6DYH FXUUHQW UHFHLYHU DV 57. %DVH. If this receiver is the
RTK rover, tap
6DYH FXUUHQW FRQILJXUDWLRQ DV 57. 5RYHU. This will
automatically set the switch to Auto Connect RTK with saved
configuration . When you tap
6HW %DVH or 6HW 5RYHU from the RTK
Survey menu, the correct COM port and settings will be set
automatically.
Base Station Receiver Setup
Use the Base Setup screen to configure a GPS receiver to be an RTK
base station and to set the base reference position in Survey Pro.
1. Tap
%DVH 6HWXS on the Survey menu to open the Current GPS
Base screen where information about the current setup is
displayed. Tap
6HWXS… to start the Base Setup wizard.
Pick the Base Point
2. Tap
6HWXS +5 to select your antenna type and measure the slant
or vertical height of the antenna.