Spectra Precision Survey Pro CE v3.60 GPS User Manual - Manual (Page 36)

GPS User’s Manual
32
SET Base at Known Geodetic Coordinate
5. Tap
6(7 to configure the base receiver with this position and
begin broadcasting RTK corrections over the radio link.
Note: If you have post processing data collection turned on, the
receiver will now open a file (with the next available default name),
start recording GPS raw data, and enter the station and antenna
information for this setup.
6. When done, you will return to the Current GPS Base screen
where the base station details are displayed.
7. Tap
&ORVH to return to the Survey menu.
GET Autonomous Base Position
If you are starting from a new point in the job, you can GET an
autonomous GPS position from the receiver to SET the base reference
position and configure the base coordinate in Survey Pro.
8. Tap
*(7 3RVLWLRQ )URP 5[ to get an autonomous position from the
receiver. If you wish to get an averaged position, enter a number
in
Average position [n] epochs before GET .
9. Check the results displayed in the edit boxes. If it looks good, tap
6(7 to configure the base receiver with this position and begin
broadcasting RTK corrections over the radio link.
Note: If you have post processing data collection turned on, the
receiver will now open a file (with the next available default name),
start recording GPS raw data, and enter the station and antenna
information for this setup.