Hired-Hand Mega-Cool rev 4-08 - Manual (Page 58)

Part No. 4801-5093 Rev 4-08 Unitized System Page 58
Curtain Installation
A RollSeal curtain has three panels: a back panel, a center panel, and a front panel. The curtain has hook & loop strips
attached to the edges. These hook & loop strips interlock with the hook & loop strips laminated on the track units,
drive pipe, and top bar. The curtain is held taut by two cylindrical weights that fit into the folds of the curtain. This
design creates a seal when the curtain is lowered, and enables the unit to be raised by a single drive.
1. Each curtain is shipped in a roll. Lay the curtain roll on the ground in front of each opening so that the curtain
unrolls away from the system.
2. Unroll the curtain slowly. (This works best if two workers pull the corners of the curtain). Note that the curtain
has three ends with hook & loop strips attached. The panel having 2
″ wide hook & loop strips on the top of the
curtain and 1
″ wide strips down each side (which offset 2.5″ from edge) is the back panel that attaches to the
back plate. The end having 1
″ hook & loop strips on the top and no hook & loop strips running down the sides
is the center panel which will attach to the drive pipe. The panel with the 1
″ strip running at top and 2″ strips on
the sides is the front panel. The front panel attaches to the top bar.
Hook & Loops on backside of
curtain attaches to hook &
loop strips on back plate.
Unroll curtain away from
opening.
Front Panel:
A third hook & loop strip at end
of roll attaches to top bar.
Back panel
Center panel
Curtain Installation