Flush system, Front view – Hired-Hand Mega-Cool rev 4-08 User Manual
Page 29

Part No. 4801-5093 Rev 4-08
Unitized System
Page 29
Flush System
It is very important to flush the system. After completing system assembly, follow
steps below in order to flush out debris from pipes.
1.
Open ball valve at end of system. See diagram above.
2.
Turn on water. Fill reservoir to fill line. Fill the Strainer Basket.
WARNING: Do not over-tighten the Strainer Basket lid. Hand-Tight ONLY.
3.
Turn on pump to flush out system.
4.
After flushing system, turn off pump.
5.
Close ball valve at end of spray line.
6.
Clean In-Line Filter.
7.
Resume normal operation.
NOTES:
1. Expect about 70 gallons of water per 50
feet of reservoir pipe.
2. Lubricate the strainer basket lid seal with
Vaseline to ensure vacuum-tight seal.
Front View
Ball Valve
Pump
To Water
Union
Strainer Basket
In-Line Filter