Hired-Hand Mega-Cool rev 4-08 - Manual (Page 21)

Part No. 4801-5093 Rev 4-08 Unitized System Page 21
Install Cool Pads & Front Covers
1. Insert pads into drip rail at bottom.
2. Fit bolts through holes in back of support
brackets as shown above.
3. Fit top of cool pad underneath spray line support
bracket and against back plate. Repeat for all
pads.
4. Fit covers into the front slots of the spray line
support brackets. Insert top flange of cover into
slots of brackets as shown above.
5. Install and tighten wing nuts to secure cover in
place.
6. Add cover splice to each joint where two covers
abut. See diagram above for cover splice.
Wing nut
Side View Side View
Cove
Cool
Pad
Mega-Cool
Cover Splice 2.55 in.
(6.5 cm)
Front View