Hired-Hand Mega-Cool rev 4-08 - Manual (Page 24)

Part No. 4801-5093 Rev 4-08 Unitized System Page 24
Install In-Line Pump Platform
The In-Line Pump Platform should be attached near the Float
Valve Assembly as close to the end of the system as possible, or
for a Center-Mount In-Line Pump setup, in the middle of the
system. Refer to the figure shown.
1. Leaving room for two attachment screws as shown,
stretch a chalk line between the two Pipe Support
Brackets and mark the LEVEL position on the Pipe
Support Brackets for the top edge of the In-Line Pump
Support Brackets.
NOTE: The In-Line Pump Support Brackets should be mounted
lower than the Pipe Support Brackets as shown for ideal
In-Line Pump location.
2. Align the In-Line Pump Support Brackets with the
marks on the Pipe Support Brackets and securely mount
with #14 x 1" Hex Head TEK Screws.
3. Cut a treated 2" x 6" wood board to the appropriate
length to rest securely in the In-Line Pump Support
Brackets. Attach the wood to the brackets on both ends
with TEK screws.
NOTE: Ideal performance and priming will be maintained when
the In-Line Pump is placed closer to the reservoir outlet
and when the In-Line Pump is mounted lower in relation
to the water level of the reservoir.
TEK Screws
Pump Support
Bracket (2x)
Wood Platform
(Customer Supplied)
Figure shown with
pump assembly
completed.
8” Pipe Support
Bracket
Ideal performance is
obtained when the
pump is kept below the
reservoir water line.