Brocade Virtual ADX Administration Guide (Supporting ADX v03.1.00) - Manual (Page 95)

Brocade Virtual ADX Administration Guide 83
53-1003249-01
Configuring TACACS or TACACS+ security
2
The following command causes an Accounting Start packet to be sent to the TACACS+ accounting
server when a system event occurs, and a Accounting Stop packet to be sent when the system
event is completed.
Virtual ADX(config)#aaa accounting system default start-stop tacacs+
Syntax: aaa accounting system default start-stop radius | tacacs+ | none
Configuring an interface as the source for all TACACS
or TACACS+ packets
You can designate the lowest-numbered IP address configured an Ethernet port, loopback
interface, or virtual interface as the source IP address for all TACACS or TACACS+ packets from the
Layer 3 Switch. Identifying a single source IP address for TACACS or TACACS+ packets provides the
following benefits:
• If your TACACS or TACACS+ server is configured to accept packets only from specific links or IP
addresses, you can use this feature to simplify configuration of the TACACS or TACACS+ server
by configuring the Brocade Virtual ADX to always send the TACACS or TACACS+ packets from
the same link or source address.
• If you specify a loopback interface as the single source for TACACS or TACACS+ packets,
TACACS or TACACS+ servers can receive the packets regardless of the states of individual links.
Thus, if a link to the TACACS or TACACS+ server becomes unavailable but the client or server
can be reached through another link, the client or server still receives the packets, and the
packets still have the source IP address of the loopback interface.
The software contains separate CLI commands for specifying the source interface for Telnet,
TACACS or TACACS+, and RADIUS packets. You can configure a source interface for one or more of
these types of packets.
To specify an Ethernet port or a loopback or virtual interface as the source for all TACACS or
TACACS+ packets from the device, use the following CLI method. The software uses the
lowest-numbered IP address configured on the port or interface as the source IP address for
TACACS or TACACS+ packets originated by the device.
To specify the lowest-numbered IP address configured on a virtual interface as the device’s source
for all TACACS or TACACS+ packets, enter commands such as the following.
Virtual ADX(config)#interface ve 1
Virtual ADX(config-vif-1)#ip address 10.0.0.3/24
Virtual ADX(config-vif-1)#exit
Virtual ADX(config)#ip tacacs source-interface ve 1
The commands in this example configure virtual interface 1, assign IP address 10.0.0.3/24 to the
interface, then designate the interface as the source for all TACACS or TACACS+ packets from the
Layer 3 Switch.
Syntax: ip tacacs source-interface ethernet portnum | loopback num | ve num
The num variable is a loopback interface or virtual interface number. If you specify an Ethernet
port, the portnum is the port’s number (including the slot number, if you are configuring a chassis
device).