Brocade Virtual ADX Administration Guide (Supporting ADX v03.1.00) - Manual (Page 34)

22 Brocade Virtual ADX Administration Guide
53-1003249-01
Using the management port
1
The interface variable specifies the interface type; for example ethernet, mgmt1, loopback, pos
or ve.
4. Specify the source port for ICMP. For example:
Virtual ADX(config)# ping 172.20.2.93 source 10.37.53.174
Syntax: ping dest_ip source source_ip
The default source port is the data port. For ICMP or ping, the source port and IP address are
retrieved based on the corresponding route gateway IP address (if available in the route table).
If the destination IP address does not have a route, then you must use the data interface
default route. If the source interface is explicitly defined for ICMP, then the respective source IP
address is used.
5. Use the show ip route command to display the route table. The following example shows the
running configuration and information returned by the show ip route command:
Virtual ADX(config)# show running-config
... (output truncated for brevity)
ip route 0.0.0.0 0.0.0.0 10.37.48.1 << mgmt. def route
ip route 0.0.0.0 0.0.0.0 6.6.6.2 << data def route!
ipv6 route ::/0 mgmt1 fe80::5254:ff:fed9:5fd6 <
!
interface management 1
ip address 10.24.143.142 255.255.240.0
ipv6 address fe80::5054:ff:fe51:9f11 link-local
ipv6 enable
!
interface ethernet 1
ip address 6.6.6.1 255.255.255.0
!
end
Virtual ADX(config)# show ip route
Total number of IP routes: 4
Start index: 1 B:BGP, Be:EBGP, Bi:IBGP, D:Connected, I:ISIS, IL1 - ISIS Level
1, IL2 - ISIS Level 2, R:RIP, S:Static
O:OSPF, Oi:OSPF Inter area, O:OSPF Intra area, O1:OSPF External type 1,
O2:OSPF External type 2
(N): Don't advertise, *:Candi-default
Destination NetMask Gateway Port Cost Type Uptime
--------------------------------------------------------------------------
1 6.6.6.0 255.255.255.0 0.0.0.0 1 1/0 D 17h39m
2 10.24.128.0 255.255.240.0 0.0.0.0 mgmt1 1/0 D(N) 17h39m
3 0.0.0.0 0.0.0.0 6.6.6.2 1 1/1 S 17h39m
4 0.0.0.0 0.0.0.0 10.24.128.1 mgmt1 1/1 S(N) 17h39m
Syntax: show ip route
NOTE
The management default route feature is available from Brocade Virtual ADX version 03.0.00
onwards. Ensure that the management default route is deleted before loading an older image.
Configuring the management port
You can configure the Brocade Virtual ADX management port from for the following: