Brocade Virtual ADX Administration Guide (Supporting ADX v03.1.00) - Manual (Page 60)

48 Brocade Virtual ADX Administration Guide
53-1003249-01
Using Syslog
1
Here are some examples of log messages for CLI access.
The first message (the one on the bottom) indicates that user “dg” logged in to the CLI User EXEC
level on October 15 at 5:38 PM and 3 seconds (Oct 15 17:38:03). The same user logged in to the
Privileged EXEC level four seconds later.
The user remained in the Privileged EXEC mode until 5:59 PM and 22 seconds. (The user could
have used the CONFIG modes as well. Once you access the Privileged EXEC level, no further
authentication is required to access the CONFIG levels.) At 6:01 PM and 11 seconds, the user
ended the CLI session.
Clearing syslog entries
To remove the syslog entries displayed by the show logging command, enter the following
command.
Virtual ADX#clear logging
Syntax: clear logging
Message format
Table 3 lists the general format and explanation of a syslog message at the following message
levels:
• Emergencies (none)
• Alerts
• Critical (none)
• Errors (none)
• Warnings
• Notifications
• Informational
• Debugging
Virtual ADX(config)#show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 12 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Log Buffer (50 entries):
Oct 15 18:01:11:info:dg logout from USER EXEC mode
Oct 15 17:59:22:info:dg logout from PRIVILEDGE EXEC mode
Oct 15 17:38:07:info:dg login to PRIVILEDGE EXEC mode
Oct 15 17:38:03:info:dg login to USER EXEC mode