Brocade Virtual ADX Administration Guide (Supporting ADX v03.1.00) - Manual (Page 130)

118 Brocade Virtual ADX Administration Guide
53-1003249-01
Using the user-based security mode
4
NOTE
Once a password string is entered, the generated configuration displays the digest (for security
reasons), not the actual password.
The priv [encrypted] parameter is optional after you enter the md5 or sha password. The priv
parameter specifies the encryption that is used to encrypt the privacy password. If the encrypted
keyword is used, do the following:
• If DES is the privacy protocol to be used, enter des des-password-key and enter a 16-octet DES
key in hexadecimal format for the des-password-key. If you include the encrypted keyword,
enter a password string of at least 8 characters.
• If AES is the privacy protocol to be used, enter aes and an aes-password-key. Enter either 12
(for a small key) or 16 (for a big key) characters for the aes-password-key. If you include the
encrypted keyword, enter a password string containing 32 hexadecimal characters.
Displaying the engine ID
To display the engine ID of a management process, enter a command such as the following:
Virtual ADX(config)#show snmp engineid
Local SNMP Engine ID: 800007c70300e05290ab60
Engine Boots: 3
Engine time: 5
Syntax: show snmp engineid
The engine ID identifies the source or destination of the packet.
The engine boots represents the number of times that the SNMP engine reinitialized itself with the
same engine ID. If the engineID is modified, the boot count is reset to 0.
The engine time represents the current time with the SNMP agent.
Displaying SNMP groups
To display the definition of an SNMP group, enter a command such as the following:
Virtual ADX(config)#show snmp group
groupname = exceptifgrp
security model = v3
security level = authNoPriv
readview = exceptif
writeview = none
Syntax: show snmp group
The value for security level can be one of the following.
TABLE 15 Authentication security level
Security level Authentication
none If the security model shows v1 or v2, then security level is
blank. User names are not used to authenticate users;
community strings are used instead.
noauthNoPriv Displays if the security model shows v3 and user
authentication is by user name only.