Brocade Virtual ADX Administration Guide (Supporting ADX v03.1.00) - Manual (Page 50)

38 Brocade Virtual ADX Administration Guide
53-1003249-01
Configuring access control
1
Syntax: [no] radius-server host ip-addr | server-name [auth-port number] [acct-port number]
Syntax: [no] radius-server [key key-string] [timeout number] [retransmit number] [dead-time
number]
The ip-addr | server-name variable specifies either an IP address or an ASCII text string.
The optional auth-port variable specifies Authentication port number. The default is 1645.
The optional acct-port variable specifies the accounting port number. The default is 1646.
The key-string variable specifies the encryption key.Valid key string length is from 1 – 16.
The timeout number parameter specifies how many seconds to wait before declaring a RADIUS
server timeout for the authentication request. The default timeout is 3 seconds. The range of
possible timeout values is from 1 – 15.
The retransmit number parameter specifies the maximum number of retransmission attempts.
When an authentication request timeout, the Brocade software will retransmit the request up to
the maximum number of retransmissions configured. The default retransmit value is 3 seconds.
The possible retransmit value is from 0 – 5.
When the software allows multiple authentication servers, the dead-time parameter specifies how
long the Brocade Virtual ADX waits for the primary authentication server to reply before deciding
the server is dead and trying to authenticate using the next server. The dead-time value can be
from 1 – 5 seconds. The default is 3.
Displaying information about the security feature
To display which security features are enabled on the system, enter the following command.
Syntax: show feature
Virtual ADX1/1#show feature
l7 switching : OFF
sFlow : OFF
NAT : ON
TCS/FW : OFF
ACL : OFF
inbound ACL : OFF
GSLB controller : ON
SYN proxy : ON
SYN defence : OFF
SLB only : OFF