Brocade Virtual ADX Administration Guide (Supporting ADX v03.1.00) - Manual (Page 78)

66 Brocade Virtual ADX Administration Guide
53-1003249-01
Setting passwords
2
Displaying the SNMP community string
If you want to display the SNMP community string, enter the following commands.
The enable password-display command enables display of the community string, but only in the
output of the show snmp server command. The string is still encrypted in the startup-config and
running-config files. Enter the command at the global CONFIG level of the CLI.
Disabling password encryption
When you configure a password, then save the configuration to the Brocade Virtual ADX file system,
the password is also saved as part of the configuration file. By default, the passwords are
encrypted so that the passwords cannot be observed by another user who displays the
configuration file. Even if someone observes the file while it is being transmitted over TFTP, the
password is encrypted.
If you want to remove the password encryption, you can disable encryption by entering the following
command.
Virtual ADX(config)#no service password-encryption
Syntax: [no] service password-encryption
Virtual ADX(config)#enable password-display
Virtual ADX(config)#show snmp server
Contact:
Location:
Community(ro): .....
Traps
Cold start: Enable
Link up: Enable
Link down: Enable
Authentication: Enable
Locked address violation: Enable
Redundant module state change: Enable
L4 maximum session limit: Enable
L4 TCP SYN limit: Enable
L4 server max connection: Enable
L4 server up: Enable
L4 server down: Enable
L4 server port up: Enable
L4 server port down: Enable
L4 switch standby: Enable
L4 switch active: Enable
HTTP match-list: Enable