Brocade Virtual ADX Administration Guide (Supporting ADX v03.1.00) - Manual (Page 39)

Brocade Virtual ADX Administration Guide 27
53-1003249-01
Configuring system parameter settings
1
The num variable specifies the value for the system parameter. The minimum, maximum and
default values for a system parameter are determined by the license that is active on your system.
For actual values associated with your license, refer to the Brocade Virtual ADX Licensing Guide.
NOTE
When you upgrade the Brocade Virtual ADX with a higher or lower license, a reload is required to
trigger the updating of the system-max values.
Displaying the system parameter values
To display the configurable system parameters and their default, maximum, and current value,
enter the show default values command at any level of the CLI.
Virtual ADX(config)#show default values
sys log buffers:50 mac age time:300 sec telnet sessions:2
ip arp age:10 min bootp relay max hops:4 ip ttl:64 hops
ip addr per intf:4
when ospf enabled :
ospf dead:40 sec ospf hello:10 sec ospf retrans:5 sec
ospf transit delay:1 sec
...
System Parameters Default Maximum Current
healthck 128 300 128
ip-arp 8192 65535 8192
ip-static-arp 512 1024 512
ip-cache 8192 32768 8192
ip-filter-port 1024 1024 1024
l3-vlan 32 256 32
l4-real-server 256 256 256
l4-virtual-server 32 32 32
l4-server-port 2048 2048 2048
l4-multi-binding 32000 300000 32000
tcp-buffer 2048 16384 2048
mac 16384 32768 16384
ip-route 8192 16384 8192
ip-static-route 256 2048 256
vlan 64 4095 64
mac-filter-port 32 64 32
mac-filter-sys 64 128 64
ip-subnet-port 32 128 32
session-limit 4096 163840 4096
view 8 65535 8
virtual-interface 64 4095 64
ip6-route 16384 32768 16384
ip6-static-route 64 512 64
ip6-cache 32768 65536 32768
ip6-neigh 4096 32768 4096
ssl-concurrent-conn 8192 16384 8192
ssl-max-profiles 256 1024 256
ssl-cert-size 6144 16384 6144
ssl-v2-concurrent-co 64 512 64
ssl-cert-count 4096 4096 4096
ssl-keys 4096 4096 4096
trl-limit-v4 15000 25000 15000
trl-limit-v6 15000 15000 15000