4 entering, setting, and sending data, Entering, setting, and sending data -3, Call up the tag setting display – Yokogawa EJX440A User Manual
Page 13
<3. Operation>
3-3
IM 01C25T01-01E
1
F0304.ai
Display appears when the
HART Communicator is turned on.
Select
Device setup.
EJX:YOKOGAWA
Online
1 Device setup
2 Pres
3 AO
4 LRV
5 URV
DEL
SET
ESC
ENTER
Display
Operation
or
EJX:YOKOGAWA
Device setup
1 Process Varlables
2 Diag/Service
3 Basic Setup
4 Detailed Setup
5 Review
DEL
SAVE
HOME ENTER
×2
or
2
Select
Basic setup.
EJX:YOKOGAWA
Basic Setup
1 Tag YOKOGAWA
2 Unit kPa
3 Re-range
4 Device information
5 Xfer fnctn Linear
DEL
SAVE
HOME ENTER
3
Select
Tag.
HELP
EJX:YOKOGAWA
Tag
YOKOGAWA
YOKOGAWA
DEL
ESC
4
The display for the Tag setting
appears.
See 3.1.4 for data entry.
HELP
DEL
ENTER
5
After entering the data, set the
HART communicator with the
data entered by pressing
ENTER
(F4).
EJX:YOKOGAWA
Tag
YOKOGAWA
FI1-1A
6
Send the data to the transmitter
by pressing
SEND (F2).
7
*
flashes during communication.
When disappears, the
transmission is complete.
(ENTER)
(SEND)
HELP
DEL
ESC
ENTER
EJX:YOKOGAWA
Basic setup
1 Tag
2 Unit
3 Re-range
4 Device information
5 Xfer fncth
HELP
SEND
HOME ENTER
EJX:FI1-1A
Basic Setup
1 Tag
2 Unit
3 Re-range
4 Device information
5 Xfer fncth
HELP
SAVE
HOME ENTER
SEND
1
Check to see where
Tag is located in the menu
configuration. Then, call up the
Tag on the
display according to the menu tree (See section
3.3 Menu Tree).
Example: Call up the
Tag to change the tag number.
3.1.4 Entering, Setting, and Sending Data
Data entered using the keys is set in the HART
communicator by pressing
ENTER (F4). Then,
by pressing
SEND (F2), the data is sent to the
transmitter. Note that the data is not set in the
transmitter if
SEND (F2) is not pressed. As all the
data that has been set in the HART communicator
is held in memory unless the power is turned off, all
the data can be sent to the transmitter at once.
Operation
Entering data on the
Tag setting display.
1. Device setup
3. Basic setup
1. Tag
F0305.ai
EJX:YOKOGAWA
Tag
YOKOGAWA
YOKOGAWA
HELP
DEL
ESC
ENTER
Example: To change from Tag
YOKOGAWA to FI1-1A.
Call up the
Tag setting display.
F0306.ai
F O K O G A W A
F I K O G A W A
F I 1 O G A W A
F I 1 - G A W A
F I 1 - 1 A W A
F I 1 - 1 A W A
F I 1 - 1 A
F
I
1
-
1
A
Character to
be entered
Operation
Display
Deletes
characters.
(DEL)
When the setting display shown above appears,
enter the data as follows: