Watlow MINICHEF 2000 - Manual (Page 9)

S t e p 1 I n s t a l l t h e C o n t r o l l e r
Step 1 Install the Controller
• Select sheet metal (16-, 18-, 20- or 22- gauge panel).
• For panel knock-out patterns, see subsequent pages of this guide.
• Use #6-32 mounting studs x 0.50” length minimum, either pressed or welded.
• Install the unit with either a horizontal or vertical mounting collar position.
• Install mating connectors to unit.
Note: This device should be used in systems that incorporate a separate high limit device for safety.
Figure 8 — Mounting the M INI C HEF 2000.
Mounting Collar
in horizontal position
Panel showing recommended knock-out pattern
M INI C HEF 2000 Controller
8 ■ Wa t l o w M I N I C H E F 2 0 0 0 H a r d w a r e & S o f t w a r e S e t u p G u i d e