Watlow MINICHEF 2000 - Manual (Page 47)

D e f i n i t i o n s o f F u n c t i o n s , P a r a m e t e r s a n d Va l u e s
4 6 ■ Wa t l o w M I N I C H E F 2 0 0 0 H a r d w a r e & S o f t w a r e S e t u p G u i d e
Setup Function, continued
[time] Time Display Format
Selects the time display format in minutes/seconds, hours/minutes, or hours/ minutes/
seconds and will only appear when the selected application software set uses time for
any of its operations.
Range: [NNNSS] [`HHNN] [HNNSS] Default: [HNNSS]
[Chirp] Key Chirp
Turns the key chirp function on or off. The key chirp function makes a short audible
sound whenever a valid keypress has been made.
Range: [```on], [``OFf] Default: [``Off]
[Loc``] Menu Security Lock
Choose between [``Yes] and [```no] to lock the menu parameters. When [Loc``]
is set to [``Yes], the menu parameters are not adjustable. This parameter only
appears when the selected application software set has pre-programmed or saved
menus.
Range: [``Yes], [```no] Default: [```no]
[tc```] Thermocouple Type
Selects the type of thermocouple sensor used. Both thermocouple inputs must be of the
same type when using two. This parameter appears only when the control has thermo-
couple type inputs and the selected application software set uses at least one tempera-
ture input.
Range: [````J], [````H], [````E] Default: [````J]
Note: [````H] denotes type K thermocouple.
[rtd``] RTD Curve
Selects the RTD (resistance temperature detector) curve. When utilizing two RTD
inputs, both must use the same curve. This parameter only appears when the control
has RTD type inputs and the selected application software set uses at least one temper-
ature input.
Range: din, JiS Default: din
[tconp] WatCurve Temperature Compensation
Turns the WatCurve temperature compensation feature on or off. This parameter
appears only when the selected application software set uses at least one temperature
output in combination with a count down timer.
Range: [```on], [``OFF] Default: [``OFF]
[Ofst1] Temperature Offset, Channel 1
Adds a relative offset to the sensed temperature of input 1. This parameter appears
only when the selected application software set uses temperature input 1.
Range: -99 to 99ºF (-55 to 55ºC) Default: 0
[Ofst2] Temperature Offset, Channel 2
Adds a relative offset to the sensed temperature of input 2. This parameter appears
only when the selected application software set uses temperature input 2.
Range: -99 to 99ºF (-55 to 55ºC) Default: 0