Watlow CLS200, MLS300 and CAS200 - Manual (Page 46)

40 Communications Specification
Chapter 3: Controller Parameter Descriptions
In the following tables, “RS” in the Product(s) column indicates that the
parameter is found in controllers equipped within the Ramp and Soak
option firmware. Similarly, “EF” indicates that the parameter is found in
controllers equipped with the Enhanced Features option.
Menu/Parameter Product(s) Parameter(s)
Single-Loop Display
Setpoint All Units 5
Process Variable All Units 6
Heat Output Percent Not CAS/CAS200 8
Cool Output Percent Not CAS/CAS200 8
Control Mode Not CAS/CAS200 4 or 96
Process/Deviation/Sensor Alarms All Units 13, 64
System Alarms All Units 13, 15
Assign R/S Profile RS 46
Ramp Soak Profile RS 100
Current Segment RS 47
Time Remaining RS 48
Cycle Number RS 49
Set Mode RS 46
Reset RS 46
Global Menu
Load Setup From Job All Units Front Panel Only
Job Save Number All Units 73
Job Select Dig Inputs All Units 23
Job Sel Dig Ins Active All Units 24
Output Override Dig Input Not CAS/CAS200 Front Panel Only
Override Dig In Active Not CAS/CAS200 Front Panel Only
Startup Alarm Delay All Units 40
Ramp/Soak Time Base RS 31
Keyboard Lock Status All Units 31
Power Up Output Status Not CAS/CAS200 31
Process Power Digin Not CAS/CAS200 Front Panel Only
Controller Address Not CAS/CAS200 101
Communications Protocol All Units Front Panel Only
Communications Err Check All Units Front Panel Only
AC Line Freq All Units 31
Dig Out Polarity on Alarm All Units 31
Firmware Info All Units 34, 35, 99
Input Menu
Input Type All Units 3
Loop Name Not CAS/CAS200 77
Channel Name CAS/CAS200 only 78