Watlow CLS200, MLS300 and CAS200 - Manual (Page 23)

Chapter 1: ANAFAZE/AB Protocol
Communications Specification 17
Ordering of Heat and Cool Channel Parameters
For parameters that have both heat and cool settings the heat values are
stored in the first registers and the cool values are stored in the registers
starting at the listed address plus MAX_CH.
NOTE
Data table parameters 46 to 60 and 100 are ramp-soak
parameters. They are only used in controllers with the
ramp-soak option. Parameters 81 to 95 are enhanced fea-
tures and only available in controllers with the enhanced
features option.
Ordering of Ramp-Soak Profile Parameters
Ramp-soak profile parameters are ordered first by profile, then by
segment where applicable. So, for example, the first eight bytes of the
Ready Events parameter are the ready segment event states for the first
profile (profile A) and the next eight bytes are for profile B and so on. In
the case of the segment triggers, the first byte contains the first trigger
setting for the first segment of profile A, the second byte contains the
settings for the second trigger for the first segment of profile A, the third
byte contains the settings for the first trigger for the second segment of
profile A and so on.
Anafaze/AB Protocol Data Table
Number Description
Address
in Hex
Type Number of Bytes
0 Proportional Band/Gain 0020 UC MAX_CH * 2
1 Derivative Term 0060 UC MAX_CH * 2
2 Integral Term 00A0 UI MAX_CH * 4
3 Input Type 0120 UC MAX_CH
4 Output Type 0180 UC MAX_CH * 2
5 Setpoint 01C0 SI MAX_CH * 2
6 Process Variable 0280 SI MAX_CH * 2
7 Output Filter 0340 UC MAX_CH * 2
8 Output Value 0380 UI MAX_CH * 4
9 High Process Alarm Setpoint 0400 SI MAX_CH * 2
10 Low Process Alarm Setpoint 04C0 SI MAX_CH * 2
11 Deviation Alarm Band Value 05A0 UC MAX_CH
12 Alarm Deadband 0600 UC MAX_CH
13 Alarm Status 0660 UI MAX_CH * 2
14 Not used 06A0 128