Watlow CLS200, MLS300 and CAS200 - Manual (Page 20)

14 Communications Specification
Chapter 1: ANAFAZE/AB Protocol
Here’s a picture of the controller’s reply:
Then the host software sends a DLE-ACK:
Message Data
Some messages contain data. What the data is and how much depends
on the command used and the purpose of the message.
Data for a Read Command
For a block read command, the data block consists of one byte that
indicates the number of bytes to read (up to 244 bytes of data). The
controller sends back a packet with a data block that contains the
requested bytes.
x10 02 00 08 48 00 00 00 10 03 B0
DLE
STX
Destination device address
Source device address
Command (block write)
Status (00 = Nothing to report)
Transaction number LSB/MSB
DLE
ETX
BCC value
x10 06
ACK
DLE