Watlow Addendum to EZwarePlus - Manual (Page 27)

6) Position the cursor centered in the top third of the window layout and click to place the text.
7) From the File menu choose Save.
Add a Numeric Display to the main window:
1) On the Objects menu,
click Numeric/ASCII
and choose Numeric
Display.
2) Click the General tab.
3) In Description type
Process Variable.
4) For PLC name choose
Modbus RTU Master
or Modbus TCP/IP
Master.
5) For Address choose
4x.and enter the
address of the Analog
Input 1 Process Value.
See the table.
(027)
For this controller…
This
parameter… Enter this
Address*… Choose this
Data Type…
RMCxxxx-xxxxxxx
Analog Input 1
Process Value
361 32-bit Float
RMHx-xxxx-x1xxx 381 32-bit Float
PMxxxxx-xxxxxxx 361 32-bit Float
STxx-xxMx-xxxx 20 32-bit Float
ST via RUI Gateway 361 32-bit Float
Other Controllers Consult the controller manual.
*These addresses have already been changed to the absolute form required
for EZwarePlus by adding 1 to the value listed in the Watlow manual. Enter
them as listed.
6) Click the Numeric
Format tab.
7) In Data format set the
data type.
8) Set Right of decimal
Pt. to 1.
(028)
9) On the Font tab set
Align to Right.
10) Click OK.
(029)
Silver Series EM OIT  27  Watlow Addendum