Watlow Addendum to EZwarePlus - Manual (Page 12)

6) In the System
Parameter
Settings dialog,
under the Device
List, click New…
(002)
7) For PLC type,
choose the
appropriate driver.
See the table
below.
8) For PLC I/F,
choose the
appropriate
hardware interface.
See the table
below.
9) For PLC default
station no. type
the controller’s
address. Typically
this is 1 for the
first controller.
10) Click Settings…
(003)
For part numbers like… with… For PLC type choose… For PLC I/F choose…
STxx-xxx-xxxx
PMxxxxx-1xxxxxx
RMCxxxx-xxxx1xx
RMHx-xxxx-x1xx
RMLx-xxxx-x1xx
RMSx-xxxx-x1xx
Modbus RTU Modbus RTU Master RS-485 2W
Silver Series EM OIT  12  Watlow Addendum