Watlow Addendum to EZwarePlus - Manual (Page 16)

5) For PLC name choose
the Modbus Master or
Modbus TCP/IP
Master.
6) For Device type
choose 4x.
(075)
7) For Address enter the
address of the heat
power for your
controller. See the
table.
8) Select the data type in
the field below the
Address field. See the
table.
9) Click OK.
For this
controller… This
parameter… Enter this
Address*… Choose this
Data Type…
RMCxxxx-xxxxxxx Heat Power 2245 32-bit Float
RMHx-xxxx-x1xx Heat Power 4125 32-bit Float
PMxxxxx-xxxxxxx Heat Power 1905 32-bit Float
STxx-xxMx-xxxx Heat Power 237 32-bit Float
ST via RUI Gateway Heat Power 1901 32-bit Float
Other Controllers Consult the controller manual.
*These addresses have already been changed to the absolute form
required for EZwarePlus by adding 1 to the value listed in the Watlow
manual. Enter them as listed
Silver Series EM OIT  16  Watlow Addendum