Watlow Addendum to EZwarePlus - Manual (Page 18)

27) Double-click the meter
to open the Meter
Display Object’s
Properties dialog.
28) Click the Profile tab.
29) Set X to 140.
30) Set Y to 60.
31) Set Width to 140.
32) Set Width (%) to 100.
33) Click OK.
34) From the File menu
choose Save.
(012)
Add a Numeric Display
This example assumes you have created a window in a project that is configured to communicate with a
Watlow Controller and that window is open in EZwarePlus.
1) On the Objects menu,
click Numeric/ASCII
then choose Numeric
Display.
2) Click the General
tab.
3) In Description type
Actual Closed Loop
Set Point.
4) For PLC name
choose Modbus RTU
Master or Modbus
TCP/IP Master.
5) For Address choose
4x and enter the
address of the Closed
Loop Working/Active
Set Point for your
controller. See the
table.
(013)
For this
controller… This
parameter… Enter this
Address*… Choose this
Data Type…
RMCxxxx-xxxxxxx
Closed Loop
Working/Active
Set Point
(Read Only)
2513 32-bit Float
RMHx-xxxx-x1xx 5233 32-bit Float
PMxxxxx-xxxxxxx 2173 32-bit Float
STxx-xxMx-xxxx 204 32-bit Float
ST via RUI Gateway 2173 32-bit Float
Other Controllers Consult the controller manual.
*These addresses have already been changed to the absolute form required
for EZwarePlus by adding 1 to the value listed in the Watlow manual. Enter
them as listed.
Silver Series EM OIT  18  Watlow Addendum