IEI Integration ECW-281B_D2550 - Manual (Page 42)

ECW-281B-D2550 Embedded System
Page 28
3.7.2 Mounting the System with Wall Mounting Kit (Optional)
To mount the embedded system onto a wall using the VESA MIS-D 100 wall mounting kit,
please follow the steps below.
Step 1: Select the location on the wall for the wall mounting bracket.
Step 2: Carefully mark the locations of the four bracket screw holes on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4: Align the wall-mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
65
Figure 3-17 ).
Figure 3-17: Wall Mounting Bracket
Step 6: Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the bottom panel of the system and tighten until the screw
shank is secured against the bottom panel (
5
Figure 3-18 ).
Step 7: Align the mounting screws on the ECW-281B-D2550 bottom panel with the
mounting holes on the bracket.