Figure 3-5: hdd thermal pad – IEI Integration ECW-281B_D2550 User Manual

Page 33

ECW-281B-D2550 Embedded System

Page 19

Step 6:

Locate the breather hole of the HDD. Cut off the corresponding area of the

breather hole from the thermal pad.

Step 7:

Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the

breather hole (

765

Figure 3-5

CAUTION:

Make sure the breather hole of the HDD is not covered. Covering the

breather hole may cause damage to the HDD.

Figure 3-5: HDD Thermal Pad

Step 8:

Replace the HDD bracket onto the bottom surface by aligning the four retention

screw holes in the HDD bracket with those in the back of the bottom surface.

Step 9:

Reinsert the four previously removed retention screws.

Step 10:

Connect the supplied SATA and power cable to the ECW-281B-D2550 and

HDD.

Step 11:

Replace the bottom surface to the bottom panel by reinserting the ten previously

removed retention screws.

Step 0: