Teledyne LeCroy Voyager Exerciser Generation Script Language Manual - Manual (Page 22)

Teledyne LeCroy Voyager USB 3.0 Exerciser Generation Script Language Reference Manual
13
7.3 Link Delay Settings
These settings specify delays that the Voyager USB 3.0 Exerciser adds when it performs
link management and packet transmission.
DelayLGOOD
Allows adding a specific delay to the response time of LGOODn.
Note that the requested time is added to the normal (minimum)
response time of the system.
Also note that time delay currently has 100 ns granularity.
Example: Set DelayLGOOD = 200
Possible values are:
delay in nanoseconds # delay to add.
0 # no delay
Default value: 0
Applicable Mode: DEVICE, HOST
DelayLGOODCnt
Specifies number of times to add DelayLGOOD.
Example: Set DelayLGOODCnt = 4
Possible values are:
positive integer # number of times to apply.
0 # no adding
0xFFFFFFFF # Apply this setting an infinite number of times.
Default value: 0
Applicable Mode: DEVICE, HOST
DelayLBAD
Allows adding a specific delay to the response time of LBADn.
Note that the requested time is added to the normal (minimum)
response time of the system.
Also note that time delay currently has 100 ns granularity.
Example: Set DelayLBAD = 300
Possible values are:
delay in nanoseconds # delay to add.
0 # no delay
Default value: 0
Applicable Mode: DEVICE, HOST
DelayLBADCnt
Specifies number of times to add DelayLBAD.
Example: Set DelayLBADCnt = 7
Possible values are:
positive integer # number of times to apply.
0 # no adding
0xFFFFFFFF # Apply this setting an infinite number of times.
Default value: 0
Applicable Mode: DEVICE, HOST