Teledyne LeCroy Voyager Exerciser Generation Script Language Manual - Manual (Page 162)

Teledyne LeCroy Voyager USB 3.0 Exerciser Generation Script Language Reference Manual
153
Bit Location Register Description Attributes
1: LTSSM will remove Rx termination upon receiving Warm
Reset LFPS signaling.
Default value is 0.
7 U3EX (U3 Exit)
0: U3 Exit handshake works normally
1: Use controlled behavior for U3 Exit response (Refer to
LTSSM_U3EXIT_CONTROL). RW
8 HRST
This bit just affects Device mode.
0: Device will pass HotReset.Active fast just by sending
minimum required TS2s with Reset bit asserted.
1: Device will remain in HotReset.Active and continue
sending TS2s with Reset bit asserted till the timeout
specified by LTSSM_HOTRESET_TIME expires. RW
9 RxDET
This bit enables controlled behavior in RxDetect state.
0: RxDetect works normally according to the spec.
1: Use controlled behavior for RxDetect (Refer to
LTSSM_RXDETECT_CONTROL) RW
31:10 Reserved, filled by 0 RO
12.1.12 LTSSM_U3EXIT_CONTROL
(Offset in the Register Area: 0x0214)
This register contains U3 Exit controlled behavior parameters; Denial Count and Delay Time. Values
specified by this register are used when U3EX bit of