Teledyne LeCroy Voyager Exerciser Generation Script Language Manual - Manual (Page 161)

Teledyne LeCroy Voyager USB 3.0 Exerciser Generation Script Language Reference Manual
152
12.1.11 LTSSM_SETTING
(Offset in the Register Area: 0x0200)
This register allows controlling the LTSSM operation through enabling/disabling of different handshakes.
It can disable the Polling.LFPS handshaking in LTSSM and cause to jump from RX_Detect to
Polling.Active directly. Also, it can disable any of the handshakes required in different steps of link training
and force the LTSSM to just move forward through training sub-states after sending appropriate number
of TS OrderedSets.
MSB LSB
Reserved
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Reserved RxDet HRST U3EX RTW BRE Idle TS2 TS1 TSEQ LFP
S
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit Location Register Description Attributes
0 LFPS
0: Polling.LFPS is enabled, 1: Polling.LFPS detection is
disabled.
Default value is 0. RW
1 TSEQ
0: LTSSM will send up to 65536 TSEQ OrderedSets and
stops sending upon reception of TS1,
1: LTSSM will send specified number of TSEQ OrderedSets
(Refer to Error! Reference source not found.).
Default value is 0. RW
2 TS1
0: TS1 handshake is enabled according to the spec,
1: TS1 detection is disabled; LTSSM will pass through
relevant sub-state just after sending specified number of
training sequences (Refer to Error! Reference source not
ound.).
Default value is 0. RW
3 TS2
0: TS2 handshake is enabled according to the spec,
1: TS2 detection is disabled; LTSSM will pass through
relevant sub-state just after sending specified number of
training sequences (Refer to Error! Reference source not
ound.).
Default value is 0. RW
4 Idle
0: Logical Idle handshake is enabled,
1: Logical Idle handshake is disabled; LTSSM will jump over
relevant sub-state.
Default value is 0. RW
5 BRE (Block Recovery Entry)
0: Normal Operation
1: When in U0, LTSSM will not respond to any TS1 received
from other party and remains in U0.
Default value is 0. RW
6 RTW (Remove Termination on Warm reset)
0: Normal Operation RW