Teledyne LeCroy Voyager Exerciser Generation Script Language Manual User Manual

Page 145

Teledyne LeCroy

Voyager USB 3.0 Exerciser Generation Script Language Reference Manual

136

##########################################################################
# Framing Corruption settings

# Binary bit masks defining which symbols to
# corrupt in framing sequences. Bit 0 = 1 symbol, bit 1 = second etc.

const

CRPT_SYM1 =

_0001

# 0x1

const

CRPT_SYM2 =

_0010

# 0x2

const

CRPT_SYM3 =

_0100

# 0x4

const

CRPT_SYM4 =

_1000

# 0x8

Set

ErrCorruptSHPMap = CRPT_SYM1

# Symbol 1 in the SHP framing sequence

# to be corrupted

Set

ErrCorruptSHP =

# Perform SHP framing corruption error

# 16 times, then use correct framing.

Set

ErrCorruptSDPMap = CRPT_SYM1 | CRPT_SYM3

# Symbol 2 and 3 in the SDP

# framing sequence to corrupt

Set

ErrCorruptSDP =

# Perform SDP framing corruption error 5 times,

# then use correct framing.

Set

ErrCorruptENDMap =

_0101

# Symbols 1,3 in the SLC framing sequence

# to be corrupted

Set

ErrCorruptEND =

0xFFFFFFFF

# !!! ALWAYS Perform END framing

# corruption error !!!

Set

ErrCorruptSLCMap =

_1100

# Symbols 3,4 in the SLC framing sequence

# to be corrupted

Set

ErrCorruptSLC =

# Perform framing corruption error 2 times,

# then use correct framing.

##########################################################################
# LTSSM Settings

# LTSSM Setting flags

const

DISABLE_LFPS =

0x1

# disables Polling.LFPS detection

const

CUSTOM_TSEQ =

0x2

# send specified number of TSEQ

# (TSEQNumber setting) then go to the next state.

const

CUSTOM_TS1 =

0x4

# send TS1 for specified period of time

# (TS1Time setting) then go to the next state.

const

CUSTOM_TS2 =

0x8

# send TS2 for specified period of time

# (TS2Time setting) then go to the next state.

const

DISABLE_IDLE =

0x10

# disables Logical Idle handshake.

# LTSSM will jump over relevant sub-state.

# setting 0 means AUTO
# DISABLE_LFPS | CUSTOM_TSEQ | CUSTOM_TS1 | CUSTOM_TS2 | DISABLE_IDLE

Set

LTSSMSettings = CUSTOM_TS1

# number of TSEQ Ordered Sets to be sent in Polling.RxEQ sub-state,
# if CUSTOM_TSEQ bit is set in LTSSMSettings setting.

Set

TSEQNumber =

64000

# Specifies time of staying in Polling.Active or Recovery.Active sub-states
# regardless of received pattern,
# if bit CUSTOM_TS1 of the LTSSMSettings is set.

Set

TS1Time =

2000