Remote communication setup, Configuring the remote control assistant event log – Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual User Manual
Page 99

Getting Started Manual
922172-00 Rev A
91
Remote Communication Setup
If you are connecting the oscilloscope to a network, first contact your
Information Systems administrator. If you are connecting the oscilloscope
directly to your PC, connect an Ethernet cable between them.
1. Touch Utilities Utilities Setup... from the menu bar.
2. Touch the Remote tab.
3. Make a Port selection:TCPIP (transmission control protocol/Internet
protocol) is the only supported port at this time.
4. Press the Net Connections button. The Windows Network and Dial-up
Connections screen is shown.
5. Touch Make New Connection and use the Windows Network
Connection Wizard to make a new connection. Or, touch Local Area
Connection to reconfigure the oscilloscope's connection if it is already
connected to the network.
Configuring the Remote Control Assistant Event Log
1. Touch Utilities Utilities Setup... from the menu bar.
2. Touch the Remote tab.
3. Touch inside the Log Mode data entry field.
4. Select Off, Errors Only, or Full Dialog from the pop-up menu.
5. Export the contents of the event log to an ASCII text file by touching
the Show Remote Control Log button. The Event Logs pop-up is
shown. Touch inside the DestFilename data entry field and use the
pop-up keyboard to provide a file name. Now, touch the Export to Text
File button.