Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 57)

Getting Started Manual
922172-00 Rev A 49
The format is Px:Name(source) with value and status contained as follows:
P1, P2,
P3, P4,
P5, P6
The number of the parameter measurement. P means Parameter.
Each parameter is uniquely identified.
Name In the example in step 3 (above), max is the parameter name, short
for maximum. A brief definition of each parameter is included in the
measurement selection dialog box.
(source) The source can be a channel (Cx), a zoom trace (Zx), a math trace
(Math), or a memory (reference waveform) (Mx)
value The last measured value in the acquisition.
status An indication of whether the parameter was calculated correctly. A
green check mark means that the measurement was performed
correctly. Reference the following table for information on other status
symbols.
Status Symbols
Below each parameter appears a symbol that indicates the status of the
parameter, as follows:
A green check mark means the oscilloscope is returning a valid
value.
A crossed-out pulse means the oscilloscope is unable to
determine top and base. However, the measurement could still
be valid.
A downward pointing arrow indicates an underflow condition
(signal below the grid area).
An upward pointing arrow indicates an overflow condition
(signal above the grid area).
An upward-and-downward pointing arrow indicates an
underflow and overflow condition (signal below and above the
grid area).