Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 101)

Getting Started Manual
922172-00 Rev A 93
Setting the Date and Time
The instrument gives you the choice of manually setting the time and date
or getting it from the Internet. If you elect to get the time and date from
the Internet, you need to have the oscilloscope connected to the Internet
through the LAN connector on the rear panel. You can also set time zones
and daylight savings time.
Manually Setting the Date and Time
1. Touch Utilities  Utilities Setup... from the menu bar.
2. Touch the Date/Time tab.
3. Touch inside each of the Hour, Minute, Second, Day, Month, and Year
data entry fields and enter a value, using the pop-up numeric keypad.
4. Touch the Validate Changes button.
Setting the Date and Time from the Internet
The Simple Network Time Protocol (SNTP) is used.
Ensure that the scope is connected to the Internet through the LAN
connector on the back of the oscilloscope.
1. Touch Utilities  Utilities Setup... from the menu bar.
2. Touch the Date/Time tab.
3. Touch the Set from Internet button.
Setting the Date and Time from Windows
1. Touch Utilities  Utilities Setup... from the menu bar.
2. Touch the Date/Time tab.
3. Touch the Windows Date/Time button.
4. Use the Time & Date Properties window to configure the time,
including time zone.