IAI America LSA-W21SS User Manual
Page 54
40
[4] Move the slider by hand over its full stroke and see the stainless sheet from above to confirm that
the specified dimensions on both sides of the stainless sheet are roughly uniform across the entire
length, as shown in the figure.
If these dimensions are not uniform across the entire length, the stainless sheet is bent. Remove
and install the stainless sheet again.
[5] Use an Allen wrench of 2.5 mm across flats to securely tighten the bolts that have been tightened
only loosely, to secure the stainless sheet.
These dimensions on both sides must be
roughly uniform.
Top stainless-sheet retainer plate