IAI America LSA-W21SS - Manual (Page 45)

31
13.2 Adjusting the Stainless Sheet Tension
[1] First, affix the stainless sheet uniformly on the right and left in a manner free from meandering.
(The stainless sheet is held in position by the attraction forces of magnets. Therefore, lift the sheet
from one end and then put it back in place toward the same end to achieve better result. Also
adjust the stainless sheet from the slider center toward both ends.)
[2] Move the slider to a position near the stroke center, and remove the stainless-sheet retainer plate
on either side.
[3] Adjusting the Stainless Sheet Tension
Remove the inspection cover located on one side of the slider cover to reveal the interior of the
slider.
Adjust the sheet in the axial direction uniformly on the right and left until the height of the apex of
the slider curve comes to 1.0 mm below the installation surface of the slider cover. In this position,
loosely tighten the mounting screws on the sheet retainer plate (hexagonal socket head button
bolt M4 x 10).
Move the slider to a position near the stroke center.
Remove the stainless-sheet retainer plate on either side.
Clea
ran
c
e =
1.0