IAI America LSA-W21SS - Manual (Page 52)

38
(5) Install the stainless sheet.
[1] Move the slider to near the center of the stroke, and insert the stainless sheet into the slider and
guide it through the slider, as shown in the figure.
Caution:
The permanent magnets have very strong magnetic force, so if you are not careful, the
stainless sheet may be attracted to the magnet and become bent to the point where it can
no longer be used. Exercise caution.
[2] Align the stainless sheet with the marker lines. Put the top stainless-sheet retainer plate over the
stainless sheet and tighten the bolts at one end using an Allen wrench of 2.5 mm across flats to
secure the stainless sheet at one end.
The slider should be
positioned near the
center of the stroke.
Stainless sheet
Rollers Rollers
Stainless sheet Slider
Marker line
Top stainless-sheet retainer plate