IAI America LSA-W21SS - Manual (Page 24)

10
7.2 Installation Surface
 Ensure
that the frame offers sufficient structural rigidity to prevent generation of vibration.
 Install the actuator on a machined surface or other flat surface of equivalent precision. The flatness of
the installation surface must be
 0.05 mm/m or less.
 Provide sufficient space to allow for maintenance work.
 The
side and bottom surfaces of the actuator base provide reference surfaces used for alignment of
slider travel.
 If you require higher traveling precision, install the actuator using these reference surfaces.
As shown above, each side surface of the base provides a reference surface used for alignment
of slider travel. If you require higher traveling precision, therefore, install the actuator with
reference to either side surface of the base.
When installing the actuator on the frame using the base reference surfaces, provide the necessary
machining by following the drawing below.
Dimension A (mm)
2 ~ 3.5
Reference surface
Reference surface
R0.3 or less