IAI America LSA-W21SS - Manual (Page 20)

6
6. Installation, Storage/Preservation Environment
6.1 Operating Environment
The actuator should be set up in an environment, which meets the following criteria:
 Avoid direct sunlight.
 Avoid radiant heat from strong heat sources such as a furnace.
 Ambient temperature should be 0 ~ 40C.
 The humidity should be less than 85% and there should be no condensation.
 Avoid exposure to corrosive or combustible gases.
 The area should have very little dust and be suitable for normal assembly operations.
 Avoid exposure to oil mist or fluids used in cutting.

Impact and vibration must not be transmitted.
 Avoid extreme electromagnetic waves, ultraviolet rays and radiation.
 This product is not intended to be used in a chemical environment.
In general, the environment should be one in which an operator can work without protective gear.
6.2 Storage/Preservation Environment
The storage/preservation environment should be similar to the operating environment. In addition, you
must take pre-cautions against condensation if the unit is to be stored for a long period of time. Unless
there are special instructions, we do not include moisture absorption agents when shipping the unit. If you
are storing the unit where condensation might occur, then you must treat the entire package or treat the
unit itself after it is unpacked to prevent condensation. The unit can withstand up to 60
C during a short
storage/preservation interval but only up to 50
C if the storage/preservation period is longer than one
month.