IAI America LSA-W21SS - Manual (Page 43)

29
13. Replacement/Adjustment of Stainless Sheet
[Required Items]
 Replacement stainless sheet
 Hex wrench set
 Scale
 Adhesive tape
[Notes]
1. Stainless sheet tension
Improper tension of the stainless sheet can promote deterioration and wear of the sheet.
If the stainless sheet is stretched too much to the extent that the clearance with the slider cover
exceeds the specified value of 1 mm, fatigue destruction may result.
On the other hand, excessive slacks cause the stainless sheet to contact the back of the slider cover.
2. Checking the clearance between the stainless sheet and the back of the slider cover
The slider cover need not be removed when replacing and adjusting the stainless sheet.
Simply remove the inspection cover located on one side of the slider cover, and you can adjust the
stainless sheet by directly measuring and checking the clearance between the stainless sheet and the
back of the slider cover.
[Name of each part]
Stainless-sheet retainer
plates
Inspection cover Slider cover Stainless sheet