IAI America RCP2-RTCBL - Manual (Page 28)

20
7. Installation Method
7. Installation Method
7.1 Installing the Actuator
The surface on which the actuator is installed must be machined or otherwise have a flat surface of
equivalent accuracy.
This actuator is constructed to allow installation on its three different sides.
x The maximum screw-in depth varies depending on the mounting surface. Determine the length of
applicable screws by referring to the figures shown on the pages that follow.
Caution
x Never use long screws whose effective thread length exceeds the maximum screw-in depth. They
may damage the mechanical or electrical parts inside the actuator.
x Round holes and slits are provided in each mounting surface. If necessary, use these holes/slits to
position the actuator.