Controller selection (when using multiple units), 2 controller selection (when using multiple units), Axis select * axis no. 00 – IAI America RCA-P User Manual

Page 17: Axis select * axis no. 01, Axis select * axis no. 02

8-2 Controller Selection (when using multiple units)

In case of multiple units connected serially via the communication line, the axis selection screen will

be displayed. For a single unit, since there is no need to select the axis, the first screen below will not

appear (refer to Section 8.3 entitled Operational Mode Selection of this manual). The content explained

here will be based on operation of the selected axis (controller). In addition, the controller can connect

up to 16 units.

Using the

Keys, select the data inputting axis

(controller), and determine with the Return Key.

Only the connecting axis will be displayed.

Axis Select
* Axis No. 00

Axis Select
* Axis No. 01

Axis number

Axis Select
* Axis No. 02

•
•
•

Caution: If power is supplied with the PORT switch ON and power is present on

the Data Input Pendant, only powered controllers will be detected.

The content explained hereinafter will be based on operation against selected axis (controller).