IAI America RCA-P - Manual (Page 13)

7. Connection With the Controller
7-1 Connection with the Data Input Pendant
(1) Connect the Data Input Pendant Cable to the “PORT IN” connector which is located on the front of the
controller. Always turn OFF the controller Port Switch first before connecting.
(In a case of ERC, there is no Port Switch, please power off the unit.)
PORT switch
PORT IN connector
(2) After connecting, turn the controller PORT Switch ON.
7-2 How to Disengage the Data Input Pendant
Hold down the BEGIN/END Key which is located in the upper of the key pad. Select “Complete” to
finish. Afterwards, turn the controller front SW side to OFF, and remove the Data input pendant
connector.
Operation:
1. Hold down the BEGIN/END Key for more than 2.5 seconds.
2. Use the Arrow Key to select “Complete” Screen, and then press the Return Key.
3. Turn the RC Controller PORT SW OFF.
4. Remove the Data Input Pendant connector.
9