Ronan X96S MOLD LEVEL GAGE - Manual (Page 51)

47
Removing the Detector
Amplifier Circuit Board
(CBAY-6102)
Follow this procedure to remove the electrometer amplifier circuit
board:
1. Remove the amplifier cover by unscrewing the hex socket head
cap screws.
2. Remove the MS connector
from the amplifier cover.
3. Remove the two 6-32
binding head screws, which
secure the amplifier board to
the detector.
4. Using a low power (60W)
iron unsolder the detector
leads to the printed circuit
board standoffs.
CAUTION: Excessive twisting
or bending can damage the
detector leads.
CAUTION: DO NOT over heat
the detector leads. Using long-
nose pliers as a heatsink will
avoid melting the solder at the
detector feed-through.
5. Lift the
board/
connector
assembly
from the
interior of
the detector
housing.