Ronan X96S MOLD LEVEL GAGE - Manual (Page 10)

6
Configuration
Operation Operation Filtering
Level Config
Head Temp Config
Filtering Dyn Track[Enable/Disable]
Alarms MLM ch. 1 Filtering Sigma [value]
Hardware MLM ch. 2 Filtering ----- Fast TC [s]
HART Detector Fault Fast Counter [value]
System Linearization Medium TC [s]
Scan Time [ms] Slow Counter [value]
MLM Cycle [ms] Slow TC[s]
Noise Filter [value]
Level Config Monitor
Units
[in,ft,m,cm,mm]
MLM CH. 1 Filtering
Low Range [value]
High Range [value]
Dyn Track[Enable/Disable]
Sigma [value]
Head Temp Config Fast TC [s]
Fast Counter [value]
Temp Units Medium TC [s]
[degC, degF, degR, Kelvin] Slow Counter [value]
Low Range [value] Slow TC[s]
High Range [value] Noise Filter [value]
Monitor [track value]
Alarms Stats [value]
Alarm 1 Alarm [number]
Alarm 2
Alarm 3
Source [variable]
Alarm 4 Alarm Type [variable]
Alarm 5 Valid Scans [number]
Alarm 6 Setpoint [in]
Alarm 7 Setpoint 2[in]
Start Cast Hysterisis [%]
Alarm on4-20mA [type]
Alarm on 4-20mA
Hardware
None
System Hardware Underrange
Source Type Overrange
Analog Out Config Freeze
HART Output (types)
Coml Protocol(types)
System Hardware
HART CPU Card [type]
CPU Status [status]
Tag Name [name] DIO Card [type]
MultiDrop [addr] DIO Status [status]
Univ Rev [rev] Slot 3 Card [type]
Spec Rev [rev] Slot 3 Status [status]
Slot 4 Card [type]
System Slot 4 Status [status]
Slot 5 Card [type]
Serial # [number] Slot 5 Status [status]
Hardware Rev [rev] Slot 6 Card [type]
Software Rev [rev] Slot 6 Status [status]
Date [date] Slot 7 Card [type]
Hour (0-23) [hour] Slot 7 Status [status]
Minute [min] Slot 8 Card [type]
Password Slot 8 Status [status]
Dte/Tme Format [sel] Display Type [type]
Display Status [status]
HART [type]
HART Status [status]
Figure 2 – Configuration Menus (1 of 2)