Ronan X96S MOLD LEVEL GAGE - Manual (Page 26)

22
Digital Inputs Menu
This menu is used to view and configure the digital inputs. It contains the following items:
ITEM FUNCTION
MLM Input 1 Selecting this item takes the user to the MLM Input 1 menu
MLM Input 2 Selecting this item takes the user to the MLM Input 2 menu
Input 1 Selecting this item takes the user to the Input 1 menu
Input 2 Selecting this item takes the user to the Input 2 menu
Input 3 Selecting this item takes the user to the Input 3 menu
Input 4 Selecting this item takes the user to the Input 4 menu
Input 5 Selecting this item takes the user to the Input 5 menu
Input 6 Selecting this item takes the user to the Input 6 menu
Input 7 Selecting this item takes the user to the Input 7 menu
Input 8 Selecting this item takes the user to the Input 8 menu
Auto Cal
This menu is used to show/allow the user to modify the time period required at the digital input before activating a remote low
level or high level calibration.
ITEM FUNCTION
Ref Delay Shows and allows the user to change the time for the Reference Delay
Local Low Level Shows and allows the user to Enable or Disable and/or set the Local Low Level [0.000]
Local High Level Shows and allows the user to Enable or Disable and/or set the Local High Level [6.000]
Remote Low Level Shows and allows the user to select the Remote Low Level
Remote High
Level
Shows and allows the user to select the Remote High Level
Calibration Menu
This menu is used to view and control the calibration of the X96S Mold level Gage. It contains the following items:
ITEM FUNCTION
Ref Constants Selecting this item takes the user to the Ref Constants menu
Calibrate Selecting this item takes the user to the Calibrate menu
Last Ref Date Shows the date on which the gage was most recently Low Referenced
Last Ref Time Shows the time when the gate was most recently Low Referenced
Loop Config Selecting this item takes the user to the Loop Config menu
MLM Outputs Cfg Selecting this item takes the user to the MLM Outputs Cfg menu
Ref Constants Menu
This menu is used to view and control the reference constants used in the reference and calibration procedures. It contains the
following items:
ITEM FUNCTION
Ref Time Shows and allows the user to set the number of seconds of data to collect for a reference
or calibrate sample
MinRefCnts Shows and allows the user to set the minimum raw value to use for a reference or
calibrate sample
MaxRefCnts Shows and allows the user to set the maximum raw value to use for the high range
calibrate sample