Ronan X96S MOLD LEVEL GAGE - Manual (Page 20)

16
ITEM FUNCTION
Setpoint Shows and allows the user to set the alarm set point
Setpoint2 Shows and allows the user to set the second alarm set point 3
Hysterisis Shows and allows the user to set the alarm hystersis percent
Source is one of the following:
Source MEANING
Level Uses the linerarized level for the source of the alarm
MLM Ch. #1 Level Uses the MLM Ch. #1 Level for the source of the alarm
MLM Ch. #2 Level Uses the MLM Ch. #2 Level for the source of the alarm
Head Temp Uses the Head Temperature of the detector for the source of the alarm
Filtered Counts Uses the Filtered Counts from the detector for the source of the alarm
Alarm Type is one of the following:
Alarm Type MEANING
None Alarm not yet set
Low Alarm when the source is equal to or lower than Setpoint
High Alarm when the source is equal to or higher than Setpoint
Range Alarm when the source is equal to or lower than Setpoint OR the source is equal
to or higher than Setpoint2
Hardware Menu
The Hardware menu is used to define the type of hardware used to provide measurements and radiation. It contains the
following items:
ITEM FUNCTION
System Hardware Shows the user to a list of the hardware modules in the system and the status of these
modules
Source Type Selecting this item takes the user to the Source Type menu
Analog Out Cnfg Shows and allows the user to set the source of power as internal or external
HART Output Shows and allows the user to adjust the HART Output function
Com1 Protocol Shows and allows the user to adjust the Com1 Protocols [None/HART/RonanSetup]
3 The second alarm set point is only used when the alarm type is range.