Ronan X96S MOLD LEVEL GAGE - Manual (Page 16)

12
Status Display Menu
The Status Display menu is used to configure the device status display. It contains the following items
ITEM FUNCTION
Analog Bar Shows the current state of the analog bar display (enabled or disabled) and allows the
user change the state
Line 1: Shows the data to be displayed on line 1 of the status display and allows the user to
change the selection
Line 2: Shows the data to be displayed on line 2 of the status display and allows the user to
change the selection
Line 3: Shows the data to be displayed on line 3 of the status display and allows the user to
change the selection
Line 4: Shows the data to be displayed on line 4 of the status display and allows the user to
change the selection
Line 5: Shows the data to be displayed on line 5 of the status display and allows the user to
change the selection
Line 6: Shows the data to be displayed on line 6 of the status display and allows the user to
change the selection
Line 7: Shows the data to be displayed on line 7 of the status display and allows the user to
change the selection
Line 8: Shows the data to be displayed on line 8 of the status display and allows the user to
change the selection
Each line may select one of the following:
SELECTION MEANING
Level Level [Std. Update]
Nonlinear Nonlinear level [no curve correction]
MLM Level 1 Level [Fast Updates]
MLM Level 2 Level [Fast Updates]
Head Temp Head temperature [if available]
4-20 mA 4-20 mA output level
Raw Counts Raw counts (from scintillation detector) or raw analog measurement (from ionization
detector (non-filtered)
Filtered Counts Filtered counts (from scintillation detector) or (from ionization detector)
Date & Time Current date and time
MLM Out 1 Output from MLM 1
MLM Out 2 Output from MLM 2
MLM Filter 1 Monitor Shows the current state of the filtering mechanism for MLM 1
MLM Filter 2 Monitor Shows the current state of the filtering mechanism for MLM 2
Diagnostic Selecting this choice takes the user to the Diagnostic Menu
Not Assigned Blank line
Configuration Menu
The Configuration menu is used to access area configuration menus. It contains the following items:
ITEM FUNCTION
Operation Selecting this choice takes the user to the Operation menu
Level Config Selecting this choice takes the user to the Level Config menu
Head Temp Config Selecting this choice takes the user to the Head Temp Config menu
Alarms Selecting this choice takes the user to the Alarm menu
Hardware Selecting this choice takes the user to the Hardware menu
HART Selecting this choice takes the user to the HART menu
System Selecting this choice takes the user to the System menu