Safety precautions – Ronan X96S MOLD LEVEL GAGE User Manual
Page 33
29
Safety Precautions
During installation the RSO will provide guidelines to
assure safety. Consider the information presented in
the Regulation/Safety Chapter of this manual, as well as
the following general guidelines:
The source holder must remain padlocked in the OFF position until
installation is complete.
Take all necessary precautions to assure that the source holder is
not dropped or damaged.
A specifically licensed individual MUST inspect the installation
prior to placing the source holder in the ON position.
Always turn the source holder to the OFF position when working
around it, the detector, or the area between these two components
which is referred to as the "measuring gap."
When the source holder is placed in the ON position, avoid the
"active beam."