Ronan X96S MOLD LEVEL GAGE - Manual (Page 27)

23
Calibrate Menu
This menu is used to access the various calibration procedures. It contains the following items:
ITEM FUNCTION
Low Calibrate Selecting this item takes the user to the Low Calibrate menu
High Calibrate Selecting this item takes the user to the High Calibrate menu
Low Calibrate Menu
This menu is used to perform the low calibrate procedure. It contains the following items:
ITEM FUNCTION
Perform Low Cal This item invokes a method that performs the low calibrate procedure
Calibr. Mode This allows the user to select the method of calibration (empty mold/process/absorber)
Low Cal Level Shows and allows the user to set the low cal level value
Low Cal Counts Shows the raw captured counts for the low calibration
High Calibrate Menu
This menu is used to perform the high calibrate procedure. It contains the following items:
ITEM FUNCTION
Perform High Cal This item invokes a method that performs the high calibrate procedure
Calibr. Mode This allows the user to select the method of calibration (empty mold/process/absorber)
High Cal Level Shows and allows the user to set the high cal level value
High Cal Counts Shows the raw captured counts for the high calibration
Loop Config Menu
This menu is used to access the primary 4-20mA loop calibration procedures. It contains the following items:
ITEM FUNCTION
Loop test This item invokes a method that performs a test on the primary 4-20mA current loop
Damping Shows and allows the user to set the damping constant for the primary 4-20mA current
loop
D/A trim This item invokes method that performs the D/A trimming of the primary 4-20mA
current loop
MLM Outputs Cfg Menu
This menu is used to access the MLM Outputs configuration. It contains the following items:
ITEM FUNCTION
MLM Out 1 Test This item invokes a method that performs a test on the primary 4-20mA (or 0-10 volt
MLM Out 1) loop
MLM Out 1 Trim This item invokes a method that performs the D/A trimming of the MLM1 4-20mA (or
0 – 10 volts) loop
MLM Out 2 Test This item invokes a method that performs a test on the primary 4-20mA (or 0-10 volt
MLM Out 2) loop
MLM Out 2 Trim This item invokes a method that performs the D/A trimming of the MLM2 4-20mA (or
0 – 10 volts) loop